کدهای خطای MID 136

A new modulator has been installed, and a faulty modulator has been installed. Check other fault codes, disconnect the modulators one by one; the error will disappear when the faulty modulator is disconnected.

The modulator doesn't match the data stored in the control unit, the control unit is faulty, the wires are incorrectly connected or damaged. Check the wires and the integrity of the data channel.

The component is not configured, the wires or contacts in the connectors are damaged, or the control unit is faulty. Check the vehicle configuration and check the wires for short circuits.

Short circuit to positive in the wires, damaged wiring or connectors in the contacts, faulty control unit. Clear fault codes, check for short circuits in the wires to another signal circuit. As a last resort, replace the EBS control unit.

The wires are shorted to negative, the wires or contacts in the connectors are damaged, or the control unit is faulty. Clear the fault codes, check the wires for shorts to ground or to another signal circuit. As a last resort, replace the EBS unit.

Broken wires, faulty EBS unit. Check wiring and connector contacts.

There's a short circuit to another signal, damaged wires or connector contacts, or a faulty EBS unit. Clear fault codes, check the wires for shorts to ground or to another signal. As a last resort, replace the EBS unit.

There's a short circuit to another signal, damaged wires or connector contacts, or a faulty EBS unit. Check for other fault codes in the EBS system and check the wiring for shorts.

There's a short circuit to another signal circuit or a broken wire. The EBS unit is faulty. The locking valve parameter is not activated in the EBS unit. Check the EBS unit parameters and check for short circuits to the signal circuit.

Short circuit to positive in the wires, faulty locking valve, or faulty EBS unit. Check the wiring and connections in the connectors between the EBS unit and the locking valve.

Short circuit to negative in the wires, faulty locking valve, or faulty EBS unit. Check the wiring and connections in the connectors between the EBS unit and the locking valve.

Short circuit to positive in the wire from the switch lamp to the EBS unit. Check the wiring for short circuits.

There's a short circuit to negative in the wire from the switch lamp to the EBS unit. The switch is faulty. Check the wiring for shorts. If the wires are normal, replace the switch.

Short circuit to positive in the wire from the switch lamp to the EBS unit. Check the wiring for short circuits.

There's a short circuit to negative in the wire from the switch lamp to the EBS unit. The switch is faulty. Check the wiring for shorts. If the wires are normal, replace the switch.